Common problems and solutions of 3D printer equipment

Explain the three common problems of 3D printer.

1、 When using a 3D printer, what if it is easy to "tilt the edge"

This kind of situation often occurs when we use 3D printer. The phenomenon of "edge warping" will appear at the bottom of 3D printing model, resulting in 3D printing failure. It is a pity. Let's not rush at this time. Coping strategies:

① We can adjust the distance between the printing platform of the 3D printer. The "edge warping" of the 3D printing model occurs because the distance between the printing platform is too large, resulting in the model not sticking tightly to the bottom. We need to re adjust the platform and re control the distance between the platforms. Of course, the 3D printer of forest industry technology can be intelligently leveled, and there will be no similar situation.

② The second situation is that the adjustment temperature of the 3D printer is not very high, resulting in the 3D printing model base, which is not completely melted, resulting in inability to stand on the base. Generally speaking, we use 3D printers. For different 3D printing materials, the temperature settings of the platform are different, such as; Plo3d printing material, set 60-70 °; Print ABS setting temperature about 100 °.

③ When we use the printing platform without high-temperature adhesive tape, we can improve the viscosity by sticking high-temperature adhesive tape.

2、 What should I do if there is a model shift when using a 3D printer?

When we use 3D printer to print the model, the printing fails due to the offset of the position, which is often a headache. The following small series summarizes the solutions:

① It is entangled or blocked by foreign matters. When it is checked whether the cross slide is entangled by wires or blocked by foreign matters, the foreign matters shall be eliminated

② When there is too much dust on the optical axis and the friction increases, you can wipe it with paper towel or cloth and alcohol to remove the dust stuck by oil stain.

③ Check all synchronization wheels on the optical axis of 3D printer and TV to see if they are loose and tighten them.

④ If you can't find the specific reason, please contact the after-sales department.

3、 What should I do if the wire output of 3D printer is not smooth?

When we operate the 3D Printing feed, we find that the wire outlet of the nozzle is not smooth, which may be caused by the following reasons:

① The temperature of the nozzle of 3D printer does not reach the optimal melting point of 3D printing material. We can adjust the temperature appropriately to ensure the smooth silk output.

2. The 3D printer's feeding plate is tied up, and the 3D printing material can not be supplied. After cutting off the 3D printing material, then adjusting the 3D printing material, and then re printing.

③ It may also be that the diameter of 3D printing material is too large. Cut off the 3D printing material and replace it with better 3D printing material.

④ It is also possible that the nozzle of the 3D printer is damaged. You can call the forest industry hotline to replace the nozzle.

The above is the content explained today. I hope it can be helpful to you.